Tag Archives

Reclaimed Wood

Primitive Upcycling & Recycling DIY: Projects

DIY: Primitive Wood Bench

EPEngineer By EPEngineer1 min read874 views

I enjoyed spending the whole day with my family outdoors today as I watched my kids running around the backyard, giggling while hunting for Grasshoppers as I was building a second Reclaimed Primitive Wood Bench. These are the days we cherished the most since the cold weather is setting in slowly but surely and we might not have an opportunity to spend time outdoors until next year.

Materials/Tools Needed:

  • Scrap/Reclaimed Wood
  • Screws
  • Drill, Drill-bits
  • Spray Paint/Paint/Stain
  • Wood Chop Saw
  • Wood File

Step by step:

  • Decide how big or small you want your bench to be
  • Decide on the design of the legs (for my bench I decided on a 30 degree angle for the cut on the legs since the bench is not deep)
  • Measure and cut your wood
  • Screw your pieces together
  • Using a wood file, file the rough/sharp edges of the wood to prevent splinters
  • Wash the bench to ensure that the paint will stick to the wood
  • Let dry and paint or stain
Reclaimed Primitive Wood Bench.
Reclaimed Primitive Wood Bench.

I hope you find this tutorial helpful and get creative building yours.

Pages:
EPEngineer By EPEngineer
Upcycling & Recycling Home Improvement DIY: Projects

DIY: Plexiglass on Tree Trunk

EPEngineer By EPEngineer2 min read724 views

About 3 years ago I came across a piece of thick plexiglass which I knew that I wanted, but did not know what to use it for. Time passed and about a month ago, while cleaning the garage, I came across it again. This time I decided to file down the edges to round them off and make it usable. As luck would have it, I needed to place it on a surface to round it off and after looking around for a bit; found myself a tree trunk that was the perfect size.

An hour later and the piece of plexiglass was ready to use and while looking at it from different angles I found my answer. “A TABLE”. I used wood screws to drill it down to the plexiglass and used a drill bit to make the holes on the plexiglass to not crack it. Here is the result. I hope you enjoy it.

Table made with Plexiglass on salvaged Tree Trunk.

After numerous trips to Lowe’s and Home Depot, my wife asked me once again to make her a Primitive Wooden Bench. I had spotted a couple of choice piece on a pile of used wood behind our garage and now was the time to fish them out. I had seen the leg pattern from other benches and knew what they looked like, so I started with them. Once I got the correct angle in place, I cut two pieces of each for the legs and screwed them together to verify the angle.

Once done with the legs I started working on the sitting part and the back rest for it. This two pieces where cut the same size and rounded off to eliminate the possibility of splinters. I used to pieces to unite the back rest to the legs and the rest is history. You can see for yourselves the end result.

Reclaimed Wood Bench.

Enjoy!

Pages:
EPEngineer By EPEngineer